|
||
Jul 10, 2008 Important Update on Friday Conf. CallDWG LEADERSHIP SUPPORT CALLS Effective Monday, July 21st the Monday Product Assistance Conference Call will be combined with the Friday Demo Report and Transitions Call to make a new call titled, the Monday Product Assistance and Demo Report Call. The last Friday Demo Report & Transitions Call will take place this Friday, July 11th and ongoing host, Glen Azumi, will be making a formal announcement at that time. There have been numerous discussions regarding this format change and it was decided that Friday night, over the years, has proved too difficult for a number of distributors to make time for. We feel that this new Monday night combination call will now be more readily available to those that wished to call in to the Friday call but were unable to. The new formatting for the new Monday Product Assistance and Demo Report Call will allow the first 30 minutes for products discussion and question and answer period. The second 30 minutes of the call will then dedicate itself to distributors sharing their successes and demos that they had during the course of the week. There will also be assistance in perfecting your demo and the transition to sharing with your prospect that there’s a business behind the bottle. The call-in information will remain the same. This call opens at 5:50 p.m. Pacific Time and will begin at 6:00 p.m. The dial-in numbers are (646) 519-5800 or (212) 461-5800 and the pin number to access the call is still 7029#. Again this new formatting will begin on Monday, July 21st and we invite all DWG International™ distributors to join us and remember to be ready to not only learn about the DWG products but to share your successes and demonstrations that you did during the course of the week!! |
||
